These 3 tools are always available at home, which can repair the small damage of the physical doll

The product life of physical dolls is very long, and they are made of silicone and TPE materials to ensure sufficient durability. But despite their sturdiness, there is a certain degree of wear and tear, both from careless storage of dolls and from scratches caused by not being careful enough to handle them when they need to be used.

 

Do not rinse with hot water directly and blow with a hair dryer

Of course, the damage to the doll is not intentional, but unintentional, full of uncertainty. Therefore, when we have not faced these small injuries, it is necessary to keep some tools at home in case of emergency. Today, we provide you with 3 methods or tools that are enough to face unexpected situations to repair dolls. Although they seem to be very common, for doll friends who are mostly male, it may not be.

 

hair dryer

Generally, a hair dryer is always kept at home because it is a very common household appliance, although boys do not often have it. And it helps to restore the indentation on the skin of the TPE doll.

 

First, take a clean towel and moisten it a little with water, remember not to use hot water; then, place the towel over the indentation on the doll's skin, and use a hair dryer to heat the towel-covered surface. If you do it correctly, after a few repetitions, you will see the dent start to slowly disappear.

 

TPE glue

The method of the hair dryer deals with dents and sags. The TPE glue is for the damage of the doll torn. In addition to TPE glue, a long support tool such as a stick, chopsticks or any other wooden tool is required.

 

It is usually recommended to thoroughly clean the area to be repaired before repairing, mainly wearing gloves, and using tools to scrape and pick out the dirty things at the tear, which can ensure that other particles or grease will not be adsorbed on other parts of the doll. Then, use a long stick to apply the glue evenly to the torn area, and slowly squeeze the wound together with force, about 2-5 minutes, so that the glue can work.

 

After the wound is almost closed, wipe off the extruded glue with a towel. Before it is completely dry, use rubbing alcohol to remove the excess glue remaining on the skin. After that, just make sure there is no tension in the torn part, and let it dry for 24 hours. .

 

white towel

In the two processes mentioned above, towels are needed, and physical dolls have relatively high requirements for towels. Microfiber white towels are generally recommended, because TPE is a relatively soft material, and ordinary large-grain towels are too rough, which will cause the skin of the doll to "peel" when wiping; in addition, the porous nature of TPE makes it very easy to dye. , the choice of white prevents the dyes used in the production of towels from contaminating the doll.

 

In addition, if you don't have a hair dryer at home, you can also use the towel method to restore dents in the doll, especially the knees and arms. Wet the towel, note that you need to use very hot water here, unlike a hair dryer; then carefully cover the dent with a towel and tap lightly with your bare hands or with a tool. When the water cools, it needs to be re-wetted and tapped repeatedly to remove the indentation.



--Reprinted from the public account: Entity doll combat experience